Cisco Systems 3750E manual Power rps switch-number name string serialnumber, Standby, 11-36

Chapter 11 Configuring Interface Characteristics

Configuring the Cisco Redundant Power System 2300

•You can configure the priority of an RPS 2300 port from 1 to 6. Specifying a value of 1 assigns the port and its connected devices the highest priority and specifying a value of 6 assigns the port and its connected devices the lowest priority.

If multiple switches connected to the RPS 2300 need power, the RPS 2300 provides power to the switches with the highest priority. If the RPS 2300 still has power available, it can then provide power to the switches with lower priorities.

Beginning in user EXEC mode, follow these steps to configure and manage the RPS 2300:

	Command	Purpose
Step 1 power rps switch-numbername {string serialnumber}		Specify the name of the RPS 2300.
		The keywords have these meanings:
		• switch-number—Specify the stack member to
		which the RPS 2300 is connected. The range
		is 1 to 9, depending on the switch member
		numbers in the stack. This keyword is supported
		only on Catalyst 3750-E switches.
		• name—Set the name of the RPS 2300 and enter
		one of these options:
		– string—Specify the name such as port1 or
		“port 1”. Using quotation marks before and
		after the name is optional, but you must use
		quotation marks if you want to include
		spaces in the port name. The name can have
		up to 16 characters.
		– serialnumber—Configure the switch to
		use the RPS 2300 serial number as the
		name.
Step 2 power rps switch-numberport rps-port-idmode {active		Specify the mode of the RPS 2300 port.
	standby}	The keywords have these meanings:
		• switch-number—Specify the stack member to
		which the RPS 2300 is connected. The range
		is 1 to 9, depending on the switch member
		numbers in the stack. This keyword is supported
		only on Catalyst 3750-E switches.
		• port rps-port-id—Specify the RPS 2300 port.
		The range is from 1 to 6.
		• mode—Set the mode of the RPS 2300 port:
		– active—The RPS 2300 can provide the
		power to a switch when the switch internal
		power supply cannot.
		– standby—The RPS 2300 is not providing
		power to a switch.
		The default mode for RPS ports is active.

	Catalyst 3750-E and 3560-E Switch Software Configuration Guide
11-36	OL-9775-02