Cisco Systems 3750E manual End, 43-10

Chapter 43 Configuring MSDP

Configuring MSDP

	Command	Purpose
Step 3
	access-listaccess-list-number {deny	Create an IP standard access list, repeating the command as many times
	permit} source [source-wildcard]	as necessary.
	or	or
	access-listaccess-list-number {deny	Create an IP extended access list, repeating the command as many times
	permit} protocol source source-wildcard	as necessary.
	destination destination-wildcard	• For access-list-number, the range is 1 to 99 for standard access lists
		and 100 to 199 for extended lists. Enter the same number created in
		Step 2.
		• The deny keyword denies access if the conditions are matched. The
		permit keyword permits access if the conditions are matched.
		• For protocol, enter ip as the protocol name.
		• For source, enter the number of the network or host from which the
		packet is being sent.
		• For source-wildcard, enter the wildcard bits in dotted decimal
		notation to be applied to the source. Place ones in the bit positions
		that you want to ignore.
		• For destination, enter the number of the network or host to which
		the packet is being sent.
		• For destination-wildcard, enter the wildcard bits in dotted decimal
		notation to be applied to the destination. Place ones in the bit
		positions that you want to ignore.
		Recall that the access list is always terminated by an implicit deny
		statement for everything.
Step 4
	end	Return to privileged EXEC mode.
Step 5
	show running-config	Verify your entries.
Step 6
	copy running-config startup-config	(Optional) Save your entries in the configuration file.

To remove the filter, use the no ip msdp redistribute global configuration command.

	Catalyst 3750-E and 3560-E Switch Software Configuration Guide
43-10	OL-9775-02