Cisco Systems 3750E manual 12-7, Switch# show parser macro cisco-desktop

Chapter 12 Configuring Smartports Macros

Configuring Smartports Macros

	Command	Purpose
Step 7
	macro {apply trace} macro-name	Append the Cisco-default macro with the required values by using the
	[parameter {value}] [parameter	parameter value keywords, and apply the macro to the interface.
	{value}] [parameter {value}]	Keywords that begin with $ mean that a unique parameter value is
		required.
		You can use the macro apply macro-name? command to display a list
		of any required values in the macro. If you apply a macro without
		entering the keyword values, the commands are invalid and are not
		applied.
Step 8
	end	Return to privileged EXEC mode.
Step 9
	show running-config interface	Verify that the macro is applied to an interface.
	interface-id
Step 10
	copy running-config startup-config	(Optional) Save your entries in the configuration file.

You can delete a global macro-applied configuration on a switch only by entering the no version of each command that is in the macro. You can delete a macro-applied configuration on an interface by entering the default interface interface-idinterface configuration command.

This example shows how to display the cisco-desktopmacro, how to apply the macro, and to set the access VLAN ID to 25 on an interface:

Switch# show parser macro cisco-desktop

--------------------------------------------------------------

Macro name : cisco-desktop

Macro type : default

#Basic interface - Enable data VLAN only

#Recommended value for access vlan (AVID) should not be 1 switchport access vlan $AVID

switchport mode access

#Enable port security limiting port to a single

#MAC address -- that of desktop

switchport port-security switchport port-security maximum 1

#Ensure port-security age is greater than one minute

#and use inactivity timer

switchport port-security violation restrict switchport port-security aging time 2 switchport port-security aging type inactivity

#Configure port as an edge network port spanning-tree portfast

spanning-tree bpduguard enable

--------------------------------------------------------------

Switch#

Switch# configure terminal Switch(config)# gigabitethernet1/0/4

Switch(config-if)#macro apply cisco-desktop $AVID 25

Catalyst 3750-E and 3560-E Switch Software Configuration Guide

OL-9775-02 12-7