Cisco Systems 3750E manual 33-13

Chapter 33 Configuring SNMP

Configuring SNMP

Table 33-5	Switch Notification Types (continued)
Notification Type
Keyword		Description
cluster		Generates a trap when the cluster configuration changes.
config		Generates a trap for SNMP configuration changes.
copy-config		Generates a trap for SNMP copy configuration changes.
entity		Generates a trap for SNMP entity changes.
envmon		Generates environmental monitor traps. You can enable any or all of these
		environmental traps: fan, shutdown, status, supply, temperature.
flash		Generates SNMP FLASH notifications. In a switch stack, you can optionally
		enable notification for flash insertion or removal, which would cause a trap to
		be issued whenever a switch in the stack is removed or inserted (physical
		removal, power cycle, or reload).
fru-ctrl		Generates entity field-replaceable unit (FRU) control traps. In the switch
		stack, this trap refers to the insertion or removal of a switch in the stack.
hsrp		Generates a trap for Hot Standby Router Protocol (HSRP) changes.
ipmulticast		Generates a trap for IP multicast routing changes.
mac-notification		Generates a trap for MAC address notifications.
msdp		Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
ospf		Generates a trap for Open Shortest Path First (OSPF) changes. You can enable
		any or all of these traps: Cisco specific, errors, link-state advertisement, rate
		limit, retransmit, and state changes.
pim		Generates a trap for Protocol-Independent Multicast (PIM) changes. You can
		enable any or all of these traps: invalid PIM messages, neighbor changes, and
		rendezvous point (RP)-mapping changes.
port-security		Generates SNMP port security traps. You can also set a maximum trap rate
		per second. The range is from 0 to 1000; the default is 0, which means that
		there is no rate limit.
rtr		Generates a trap for the SNMP Response Time Reporter (RTR).
snmp		Generates a trap for SNMP-type notifications for authentication, cold start,
		warm start, link up or link down.
storm-control		Generates a trap for SNMP storm-control. You can also set a maximum trap
		rate per second. The range is from 0 to 1000; the default is 0 (no limit is
		imposed; a trap is sent at every occurrence).
stpx		Generates SNMP STP Extended MIB traps.
syslog		Generates SNMP syslog traps.
tty		Generates a trap for TCP connections. This trap is enabled by default.
vlan-membership		Generates a trap for SNMP VLAN membership changes.
vlancreate		Generates SNMP VLAN created traps.
vlandelete		Generates SNMP VLAN deleted traps.
vtp		Generates a trap for VLAN Trunking Protocol (VTP) changes.

	Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-02		33-13