Chapter 40 Configuring HSRP and Enhanced Object Tracking

Configuring HSRP

Figure 40-2 MHSRP Load Sharing

Active router for group 1 Standby router for group 2

Router A

Active router for group 2

Standby router for group 1

Router B

10.0.0.110.0.0.2

121235

Client 1

Client 2

Client 3

Client 4

HSRP and Switch Stacks

HSRP hello messages are generated by the stack master. If an HSRP-active stack master fails, a flap in the HSRP active state might occur. This is because HSRP hello messages are not generated while a new stack master is elected and initialized, and the standby router might become active after the stack master fails.

Configuring HSRP

These sections contain this configuration information:

Default HSRP Configuration, page 40-5

HSRP Configuration Guidelines, page 40-5

Enabling HSRP, page 40-5

Configuring HSRP Priority, page 40-7

Configuring MHSRP, page 40-9

Configuring HSRP Authentication and Timers, page 40-9

Enabling HSRP Support for ICMP Redirect Messages, page 40-11

Configuring HSRP Groups and Clustering, page 40-11

Catalyst 3750-E and 3560-E Switch Software Configuration Guide

40-4

OL-9775-02

 

 

Page 982
Image 982
Cisco Systems 3750E manual Configuring Hsrp, Hsrp and Switch Stacks, 40-4