D-Link DHS-3224V Switch User’s Guide

Features

Ports

One female RJ-21 port for connection to a VDSL splitter using Telco50 cabling.

Uplink module with one 10/100 BASE-TX port for Ethernet over VDSL Uplink.

2 x IEEE1394 (Rx + Tx) “FireWire” ports for Switch-to-Switch operations.

One female RS-232 DCE diagnostic port (console port) for setting up and managing the Switch via a connection to a console terminal or PC using a terminal emulation program.

Performance Features

Quadrature Amplitude Modulation (QAM)

Frequency Division Duplexing

Spectral compatibility with xDSL, ISDN (2B1Q/4B3T), digital PBX extensions and narrow band interference

8.8 Gbps switching fabric capacity

Store and forward switching scheme.

8K active MAC address entry table per device with automatic learning and aging (10 to 1000000 seconds).

8 MB packet buffer per device.

802.1D Spanning Tree support.

802.1Q Tagged VLAN support

Supports up to 24 end users per Switch (24 ports)

Up to 6 Switches can be stacked in a 19” equipment rack and managed as a unit

Management

Provisioning for VDSL Settings (per Port)

RS-232 console port for out-of-band network management via a console terminal.

Spanning Tree Algorithm Protocol for creation of alternative backup paths and prevention of network loops.

SNMP v.1 Agent.

Fully configurable either in-band or out-of-band control via SNMP based software.

Flash memory for software upgrades. This can be done in-band via TFTP.

Built-in SNMP management:

-Bridge MIB (RFC 1493)

-MIB-II (RFC 1213)

-Mini-RMON MIB (RFC 1757) – 4 groups

-802.1p MIB (RFC 2674).

TFTP support

BOOTP support

DHCP Client support

Password enabled.

Telnet remote control console

Web Management Software

4

Page 18
Image 18
D-Link DHS-3224V manual Ports, Performance Features, Management