Compute Sleds

Removing a Compute Sled

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came with the product.

CAUTION: To ensure proper airflow in the system, if a sled is removed it should be immediately replaced with another sled or sled blank.

CAUTION: Operating the system without a sled or sled blank installed can cause the enclosure to overheat. See "Installing a Double-Wide Sled Blank" on page 190.

1Power down the sled using OS commands or the Baseboard Management Controller, and ensure that the sled’s power is off.

When the sled is powered off, its front-panel indicator is off.

2Pull up on the compute sled release latch at the bottom of the sled to disengage the sled from the server enclosure. See Figure 3-4 or Figure 3-5.

3Using the handle, slide the sled out of the enclosure. See Figure 3-4 or Figure 3-5.

192

Installing System Components

Page 192
Image 192
Dell C8000 owner manual Compute Sleds, Removing a Compute Sled, 192