Troubleshooting a Wet Enclosure
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1Turn off the sleds and attached peripherals.
2Disconnect the enclosure from the electrical outlet or the PDU.
CAUTION: Wait until all of the indicators on the power supplies turn off before proceeding.
3Remove all sleds. See "Removing a Compute Sled" on page 192 or "Removing a Storage Sled" on page 194.
4Disassemble components from the sled. See the sled’s documentation for more information.
5Remove the fan modules. See "Removing a Fan Module" on page 207.
6Remove the front panel board. See "Removing the Front Panel Board" on page 209.
7Remove the fan controller board. See "Removing the Fan Controller Board" on page 211.
8Let the enclosure dry thoroughly for at least 24 hours.
9Reinstall the fan controller board. See "Installing the Fan Controller Board" on page 212.
10Reinstall the front panel board. See "Installing the Front Panel Board" on page 210.
11Reinstall the fan modules. See "Installing a Fan Module" on page 208.
12Reinstall all sled components you removed in step 4.
13Reinstall all sleds. See "Installing a Compute Sled" on page 194 or "Installing a Storage Sled" on page 195.
Troubleshooting