Setup Guide
To create a Community Property Group
1Administration > Network configuration > Community Property Group > Add a community property group.
2Give a name to the Community Property Group. Use a name that is meaningful to you.
3Add a description.
4Under the heading Add a Community String enter a string name, and select the appropriate Type (read or write, or both).
5Click Add.
6Repeat steps 4 and 5 for each community string that can be applied to the same set of devices or subnets.
7If necessary, select a community string and click the Move Up or Move Down buttons to move it to the right place.
When you add community strings, the order is important, make sure the most frequently used strings are at the top of the list.
8Click Submit.
To apply the Community Property Group to the IPv4 range
1Click Administration > Network configuration > Add IPv4 range.
2Click Add by interval and enter the starting and ending IPv4 addresses for the range you want.
3In the Choose existing Property Set/Group
4Click Submit.
