Delta Electronics VFD-VE Series Run/Stop, Rev/Fwd, Control Circuits of the External Terminal

				Chapter 4 Parameters
Group 2 Digital Input/Output Parameters
02-00	2-wire/3-wire Operation Control
Control	VF	VFPG	SVC FOCPG TQRPG	Factory setting: 0
mode
	Settings	0	FWD/STOP, REV/STOP

1FWD/STOP, REV/STOP (Line Start Lockout)

2RUN/STOP, REV/FWD

3RUN/STOP, REV/FWD (Line Start Lockout)

43-wire (momentary push button)

53-wire (momentary push button and Line Start Lockout)

Three of the six methods include a “Line Start Lockout” feature. When line start lockout is

enabled, the drive will not run once applying the power. The Line Start Lockout feature doesn’t

guarantee the motor will never start under this condition. It is possible the motor may be set in

motion by a malfunctioning switch.

02-00	Control Circuits of the External Terminal
0, 1		FWD:("OPEN":STO P)
2-wire operation control (1)	FWD/STOP
		("CLOSE":FWD)
FWD/STOP	REV/STOP	REV:("OPEN": STOP)
REV/STOP		("CLOSE": REV)
		DCM
		VFD-VE
2, 3		FWD:("OPEN":STOP)
2-wire operation control (2)	RUN/STOP
		("CLOSE":RUN)
RUN/STOP	FWD/REV	REV:("OPEN": FWD)
REV/FWD		("CLOSE": REV)
		DCM
		VFD-VE
4, 5		FWD "CLOSE":RUN
3-wire operation control	STOP RUN
		MI1 "OPEN":STOP
	REV/FWD	REV/FWD "OPEN": FWD
		"CLOSE": REV
		DCM
		VFD-VE

02-01Multi-Function Input Command 1 (MI1)

Factory Setting: 1

02-02Multi-Function Input Command 2 (MI2)

Factory Setting: 2

02-03Multi-Function Input Command 3 (MI3)

Factory Setting: 3

Revision August 2008, 03VE, SW V2.04 4-59