Delta Electronics VFD-VE Series manual 03-00, 03-01, 03-02

Chapter 4 Parameters

Group 3 Analog Input/Output Parameters
03-00		Analog Input 1 (AVI)
						Factory Setting: 1
03-01		Analog Input 2 (ACI)
						Factory Setting: 0
03-02		Analog Input 3 (AUI)
						Factory Setting: 0
		Settings		Control Mode
			VF	VFPG	SVC	FOCPG	TQRPG
	0: No function		○	○	○	○	○
	1: Frequency command (torque limit under TQR control		○	○	○	○	○
	mode)
	2: torque command (torque limit under speed mode)						○
	3: Torque compensation command		○	○	○	○	○
	4: PID target value (refer to group 8)		○	○	○	○
	5: PID feedback signal (refer to group 8)		○	○	○	○
	6: P.T.C. thermistor input value		○	○	○	○	○
	7: Positive torque limit					○
	8: Negative torque limit					○
	9: Regenerative torque limit					○
	10: Positive/negative torque limit					○
	11: PID feedback signal of tension		○	○	○	○	○
	12: Line speed		○	○	○	○	○
	13: Reel diameter		○	○	○	○	○
	14: PID target value of tension (tension closed-loop)		○	○	○	○	○
	15: Tension setting (tension open-loop)						○
	16: Zero-speed tension						○
	17: Tension taper						○

When it is frequency command or TQR speed limit, the corresponding value for 0~± 10V/4~20mA is 0 – max. output frequency(Pr.01-00)

When it is torque command or torque limit, the corresponding value for 0~±10V/4~20mA is 0 – max. output torque (Pr.07-22).

When it is torque compensation, the corresponding value for 0~±10V/4~20mA is 0 – rated torque.

Revision August 2008, 03VE, SW V2.04 4-79