Delta Electronics VFD-VE Series manual Parameters

Chapter 4 Parameters

	Settings		Control Mode
		VF	VFPG	SVC	FOCPG	TQRPG
	13: cancel the setting of the optimal	○	○	○	○
	acceleration/deceleration time
	14: switch between drive settings 1 and 2	○	○	○	○
	15: operation speed command form AVI	○	○	○	○
	16: operation speed command form ACI	○	○	○	○
	17: operation speed command form AUI	○	○	○	○
	18: Emergency Stop (07-36)	○	○	○	○	○
	19: Digital Up command	○	○	○	○
	20: Digital Down command	○	○	○	○
	21: PID function disabled	○	○	○	○
	22: clear counter	○	○	○	○	○
	23: input the counter value (multi-function input command	○	○	○	○	○
6)
	24: FWD JOG command	○	○	○	○
	25: REV JOG command	○	○	○	○
	26: TQC+PG/FOC+PG model selection	○	○	○	○	○
	27: ASR1/ASR2 selection	○	○	○	○
	28: Emergency stop (EF1)	○	○	○	○	○
	29: Signal confirmation for Y-connection	○	○	○	○
	30: Signal confirmation for connection	○	○	○	○
	31: High torque bias (by Pr.07-29)	○	○	○	○	○
	32: Middle torque bias (by Pr.07-30)	○	○	○	○	○
	33: Low torque bias (by Pr.07-31)	○	○	○	○	○
	34: Enable multi-step position control		○		○
	35: Enable position control	○	○	○	○
	36: Enable position learning function (valid at stop)		○		○
	37: Enable pulse position input command	○	○	○	○
	38: Disable write EEPROM function	○	○	○	○	○
	39: Torque command direction					○
	40: Force stop	○	○	○	○	○
	41: Serial position clock				○
	42: Serial position input				○
	43: Analog input resolution selection				○
	44: Reset initial reel diameter	○	○	○	○	○
	45: Reset initial reel diameter 0	○	○	○	○	○
	46: Reset initial reel diameter 1	○	○	○	○	○
	47: Reset PID control integration of tension	○	○	○	○	○
	48: Mechanical Gear Ratio Switch		○		○	○
	49: Reserved
	50: Reserved

This parameter selects the functions for each multi-function terminal.

The terminals of Pr.02-23~Pr.02-27 are virtual and set as MI7~MIB when using with optional card EMV-APP01

If Pr.02-00 is set to 3-wire operation control. Terminal MI1 is needed for the 3rd wire position. Therefore, MI1 is not allowed for any other operation.

Multi-function input commands 7-14 are the extension terminals of Pr.02-01 to Pr.02-06. There are 14 terminals but the terminals 7-14 are virtual terminals and you can set the status of bit 8- 15 of Pr.02-10 to ON or OFF by KPV-CE01 or communication.

Revision August 2008, 03VE, SW V2.04 4-61