Delta Electronics VFD-VE Series manual 00-03, Start-up Display Selection, Factory setting, 00-04

				Chapter 4 Parameters
00-02	Parameter Reset
Control	VF	VFPG	SVC FOCPG TQRPG		Factory setting: 0
mode
	Settings	0	No Function

1Read Only

2Enable Group 11 Parameters Setting

8Keypad Lock

9All parameters are reset to factory settings (50Hz, 220V/380V)

10 All parameters are reset to factory settings (60Hz, 220V/440V)

When it is set to 1, all parameters are read only except Pr.00-00~00-07 and it can be used

with password setting for password protection.

This parameter allows the user to reset all parameters to the factory settings except the fault

records (Pr.06-17 ~ Pr.06-22).

50Hz: Pr.01-01 is set to 50Hz and Pr.01-02 is set to 230V or 400V.

60Hz: Pr.01-01 is set to 60Hz and Pr.01-02 is set to 230Vor 460V.

When Pr.00-02=08, the KPV-CE01 keypad is locked and only Pr.00-02 can be set. To unlock

the keypad, set Pr.00-02=00.

When Pr.00-02 is set to 1 or 8, Pr.00-02 setting should be set to 0 before setting to other

setting.

After setting Pr.00-02 to 2, it can display group 11 to re-connect the keypad after disconnection

or re-power on after the power off.

00-03	Start-up Display Selection
Control	VF	VFPG SVC FOCPG TQRPG	Factory setting: 0
mode

Settings 0 Display the frequency command value. (LED F)

1Display the actual output frequency (LED H)

2Multifunction display, see Pr.00-04 (LED U)

3Display the output current (A)

This parameter determines the start-up display page after power is applied to the drive.

00-04	Content of Multi-Function function Display
Control	VF	VFPG SVC FOCPG TQRPG	Factory setting: 0
mode

Revision August 2008, 03VE, SW V2.04 4-39