Multi-Bin Mailbox/Mailbox With Stapler
1With the printer turned OFF and
unplugged, disconnect the power and
interface cables from the Multi-Bin
Mailbox/Mailbox With Stapler controller
PCA.
2Carefully slide the Multi-Bin
Mailbox/Mailbox With Stapler away from
the printer until the locator tabs and the
lower guide rail are clear.
To Reinstall:
1Make sure that the lower guide rail and
the locator tabs are aligned, and that the
dot pattern on the PCA connector and
cable connector match.
2Make sure that the Interlock Switch is
fully depressed.
3To connect the power cables for the
Mailbox with Stapler only: Attach the
top (longest) section of the 3-way power
adapter to the power connector on the
back side of the print engine.
Attach the middle section of the 3-way
power adapter to the power connector on
the back side of the 2000-Sheet Input
Tray.
Attach the bottom section of the 3-way
power adapter to one end of the power
supply box. Attach the other end of the
power supply box to the power connector
at the bottom of the mailbox.
Connect the single section of the 3-way
power adapter to the power cords.
Connect the power cord to a grounded
power outlet.
6-14 Removal and Replacement