EXP Computer C4077-90960 Stapling Unit Controller PCA

Stapling Unit Controller PCA
1Remove the Stapling Unit Assembly (see Figure 6-91).
2Remove the Back Plate (see Figure 6-92).
3Remove (2) screws located on the right side of the Stapling Unit, holding the
PCA board (see Figure 6-94, callout 1).
4Unplug the cables that are connected to the PCA. Identify their color and
size, and the ground cables (see Figure 6-95, callouts 1 and 2).
5The board is supported by a hooked tab at the top of the card (see Figure
6-96, callout 1). Slide the board to the left and then down.
To Reinstall:
Slide the board up and then to the right.
Caution Keep the Top Cover Assembly open while reconnecting the cables. Cable
damage could occur the next time the cover is opened if the cables are
reinstalled too tightly.
Figure 6-94
6Removal and
Replacement
Removal and Replacement 6-105