Message Error
Log
Category/
Message
Description Recommended
Action
ENGINE TEST Status This message displays after the engine test
button is pressed and indicates that the
engine test is in process. If the test fails, an
error or attendance message displays.
No action required. Refer to the
Power On section for more
information about performing an
engine test.
FORMFEEDING
(The [On Line] LED flashes.) Status A form feed is in process. No action required. When the
paper reaches the destination
output bin, the [Ready] message
displays and the [On Line] LED
returns to a steady state.
HP MIO 1 INITIALIZING Status This message displays whi le the upper HP
MIO card initializes. The printer supports I/O
switching and remains online, but the
channel is not active during initialization.
NOTE: Since older MIO cards cannot
remove the message, the printer will remove
the message after a 5-minute timeout.
No action required. If the
message displays after five
minutes, a problem may exist in
the network card, the network
configuration, or with the host.
For more information about the
MIO card, refer to your network
documentation.
HP MIO 2 INITIALIZING Status This message displays whi le the lower HP
MIO card initializes. The printer supports I/O
switching and remains online, but the
channel is not active during initialization.
NOTE: Since older MIO cards cannot
remove the message, the printer will remove
the message after a 5-minute timeout.
No action required. If the
message displays after five
minutes, a problem may exist in
the network card, the network
configuration, or with the host.
For more information about the
MIO card, refer to your network
documentation.
HP MIO 1 NOT READY Status The upper MIO card is not ready. One of two
situations may occur. First, the parallel port
and the lower MIO card may continue to
operate nominally. If the upper MIO card is
operating correctly and communicating with
the network, this message will disappear
after approximately one minute. No action is
required. Second, if the upper MIO card is
unable to communicate with the network, this
message will display for five minutes and
then disappear. In this case, the printer is not
communicating with the network, even
though the message is no longer displayed.
The problem may be a bad MIO
card, bad cable or connection on
the network, or a network
problem. For more information
about the MIO card, refer to your
network documentation. Verify
that the product numbers for the
MIO card is supported by printer.
MIO CARD NOT READY Status
18.0.x
(x=1 or 2
depending
on which
slot the card
is in.)
Upon power up, the MIO cards perform a self
test to complete initialization. Verify MIO card
is HP.
Recommended action: no action
needed. Allow time to initial ize. If
error continues, turn printer off
and reseat or move to another
MIO slot to test, verify cabling is
not damaged or defective. If error
follows MIO card, replace.
Table 7-5 Printer Control Panel Messages (continued)