Back Cover
Note The metal back cover and the plastic panel at the right rear are removed as
a single unit.
The square opening at the upper rear corner on the right side plastic panel
is the engine test access.
1Remove (5) screws, CH102 (Figure 6-4, callout 1).
2Open the top cover door and remove (1) screw, CH102 (Figure 6-4, callout 2)
3Open the 2000-Sheet Input Unit transfer door (if installed), Tray 1, and the
Right Lower Door Assembly.
4Remove (2) screws, CH102 (Figure 6-4, callout 3), from plastic panel to the
left of the metal back cover.
5Carefully release the cover around the AC input connector (Figure 6-4,
callout 4) at the lower right of the back cover and slide the right side of the
cover slightly forward.
6Carefully release the retaining tabs (Figure 6-4, callout 5) on the plastic
panel to the left of the metal back cover by gently pulling the cover to the
left while moving both pieces away from the printer chassis.
Back Cover
Figure 6-4
6Removal and
Replacement
Removal and Replacement 6-19