Motor, Transport Belt and Encoder Assembly

1Remove the left cover (see Figure 6-65).
2Remove all paper bins and the blind cover (see Figure 6-86).
3Remove the Controller PCA (see Figure 6-87).
4Remove (2) screws, CH112, from the motor assembly (Figure 6-83, callout 1).
5Remove the small drive belt (Figure 6-84, callout 2) from the motor drive
gear.
6Pull the motor and Encoder Assembly clear of the frame while guiding the
cables through the access hole in the bottom of the frame.
To Reinstall:
1Make sure that the segmented disk at the back of the Transport Belt Motor
is approximately centered in the Encoder Assembly photosensor
(Figure 6-85, callout 3).
2Replace the drive belt on the motor drive gear before installing and
tightening the screws.
Multi-Bin Mailbox/Mailbox with Stapler , Transport Belt Motor Screws
Figure 6-83
6-96 Removal and Replacement