Transfer Roller Assembly

Caution Handle the Transfer Roller from the ends only. Do not touch the surface of
the Transfer Roller. Skin oils will affect its electrical characteristics,
resulting in poor image transfer.
1Open the top cover door and remove the toner cartridge.
2Grasp the gear (Figure 6-51, callout 1) on the left end and carefully lift
upward just enough to clear the retainer clip.
3Slide the Transfer Roller Assembly to the left to release the shaft on the
right end (Figure 6-51, callout 2).
To Reinstall:
1Place the right end of the shaft into its retaining cavity.
2Hold the Transfer Roller wiper up (Figure 6-51, callout 3) and slide the
assembly to the right until the gear on the left end is in position.
3Carefully press the left end of the shaft into the retainer clip.
4Press the Transfer Roller wiper down (Figure 6-51, callout 3) until the
retaining clips snap into place.
Transfer Roller Assembly
Figure 6-51
6-64 Removal and Replacement