Configuring Novell NetWare Frame Type Parameters.
Normally selecting a NetWare frame type is not required. The HP
JetDirect card automatically selects a NetWare frame type, and only when
this selection is incorrect do you have to set the NetWare frame type
through the HP LaserJet 5Si MX control panel. The NetWare frame type is
displayed on the self test page.
To manually configure Novell NetWare parameters:
1Press [Item] until CFG NOVELL=NO * appears.
2Press [+] until CFG NOVELL=YES * appears.
3Press [Select]. CFG NOVELL=YES * appears.
4Press [Item]. FRAME=AUTO * appears.
5To configure the Novell NetWare protocol, Press [+] to select one of these
frame types:
6Press [Select] to save the selection. An asterisk * appears.
7If other protocols will be used, continue with the next section. Otherwise,
skip to “Disable Network Protocols” at the end of this appendix.
Frame Type Description
AUTO (default) All listed Novell frame types will be allowed.
EN_8023 Limit frame types to IPX over IEEE 802.3 frames. All
others will be counted and discarded.
EN_II Limit frame types to IPX over Ethernet II frames. All
others will be counted and discarded.
EN_8022 Limit frame types to IPX over IEEE 802.2 frames. All
others will be counted and discarded.
EN_SNAP Limit frame types to IPX over SNAP with Ethernet
frames. All others will be counted and discarded.
Table B-1 Novell NetWare Frame Types on an HP JetDirect Ethernet Card
BI/O Information
I/O Information B-7