Top Cover Assembly

1Remove the Stapling Unit Assembly (see Figure 6-91).
2Open the Top Cover Assembly and remove the Back Plate (see Figure 6-92).
3Unplug the ground and signal cables from the right side of the Stapling
Unit Controller board, being careful to keep them in the cable holder.
4On each side of the assembly, pull the hinge to release the (2) posts from the
retaining notches (see Figure 6-97).
To Reinstall:
Caution Keep the Top Cover Assembly open while reconnecting the cables. Cable
damage could occur the next time the cover is opened if the cables are
reinstalled too tightly.
Figure 6-97
6Removal and
Replacement
Removal and Replacement 6-107