Tray 2 and 3 Adjustment Procedure

The paper trays are mechanically aligned to the printer chassis at the
factory. Perform this procedure ONLY if a paper tray has been replaced
with a tray other than the original factory installed unit, or if the top
margin of the image area is off-center more than 0.5 mm (0.02 in.) The
adjustment procedure is identical for Trays 2 and 3.
Note Before performing this procedure, check that the margins in your software
application are properly set.
1Load the paper tray being tested with letter or A4 size paper.
2Perform a 1-sheet Paper Path Test from that tray (see Paper Path Test
under Test Menu in Chapter 3).
3Refer to Figure 4-1 and compare distance A to distance B.
Image Area Margins
(Top Of Page)
Figure 4-1
4Maintenance &
Adjustments
Maintenance and Adjustments 4-7