Feeder Assembly

1Open the left access door and remove the Duplex Unit (if installed).
2Remove the Fuser Assembly (see Figure 6-25).
3Open the Top Cover and remove the Toner Cartridge.
4Remove the Transfer Roller Assembly (see Figure 6-51).
5Remove the Registration Assembly (see Figure 6-42).
6Unplug the sensor cable at the right side of the Feeder Assembly (Figure
6-22, callout 1).
7Remove (2) screws, CH102 at the front of the Feeder Assembly (Figure 6-22,
callout 2).
8Remove (1) screw, CH101 at the back of the Feeder Assembly (Figure 6-23).
Note Removing the High Voltage Power Supply is recommended to ease the
removal of the Feeder Assembly, primarily because of the contact points.
9Release (4) plastic retaining tabs by moving them in the directions indicated
in Figure 6-23 while carefully lifting upwards on the Feeder Assembly.
10 Remove the Feeder Assembly by lifting it upwards out of the Toner
Cartridge cavity.
To Reinstall:
Make sure that the plastic retaining tabs are all properly seated before
replacing the screws.
6-36 Removal and Replacement