Top Cover
1Remove Control Panel (see Figure 6-2), and remove (1) screw, CH102
(Figure 6-8, callout 1).
2Open the Diverter Assembly access door and remove (1) screw, CH102
(Figure 6-8, callout 2).
3Open the top cover door and remove (1) screw, CH102 (Figure 6-9,
callout 3).
Caution Be careful not to damage the Face-Down Bin Full sensor flag (Figure 6-9,
callout 4) when removing the top cover.
4Lift (and hold) the top cover door up and carefully pull out on the cover to
release the retaining tab (Figure 6-8, callout 5).
5Hold the Face-Down Bin (Figure 6-8, callout 6) down while carefully and
slowly lifting the top cover straight up until it clears the Face-Down Bin
Full sensor flag and the Delivery Unit.
To Reinstall:
Caution Be careful not to damage the Face-Down Bin Full sensor flag (Figure 6-9,
callout 4) when replacing the top cover.
1Hold the top cover door up and the Face-Down bin (Figure 6-8, callout 6)
down while lowering the cover into position.
2Refer to Figure 6-9, callout 4. Slide the Face-Down Bin under the
Face-Down Bin Full sensor flag, and make sure that the cam (Figure 6-9,
callout 4) at the rear of the top cover door is properly positioned while
lowering the top cover into place.
3Make sure that the top cover is seated properly and that the retaining tabs
are in place before replacing the screws.
6Removal and
Replacement
Removal and Replacement 6-23