Metallic Tape and Housing Assembly

1Remove all of the paper bins, and the blind cover (see Figure 6-86).
2Lower the Delivery Head to the bottom of the frame.
3Release the tape retainer by pushing the tab (see Figure 6-79, callout 1).
4Carefully rewind the tape into its housing. Do not allow the tape to freely
snap back into the housing (see Figure 6-80, callout 2).
5Remove the tape housing by releasing the retaining tabs (Figure 6-81,
callout 3) and rotating it upward.
To Reinstall:
1Replace the tape housing by inserting the top of the housing into position
and snapping the housing down into place. Make sure that the tape is in
direct contact with the Transport Belt by routing it underneath the small
plastic guide.
2Insert the top end of the tape into its retainer slot and gently push it
upward to engage the retainer tab. Before replacing the tape holder, make
sure that the tape is in direct contact with the Transport Belt.
6-92 Removal and Replacement