Jam Access Door Assembly
1Remove the left and right covers (see Figure 6-65).
2Remove the Delivery Head Position Motor (see Figure 6-82).
3Remove all paper bins and the blind cover (see Figure 6-86).
4Release the upper end of the Metallic Tape (see Figure 6-79).
5Release (2) retaining springs (Figure 6-74, callout 1).
6From the front of the unit, remove (1) e-clip from the right end of the shaft
(Figure 6-75, callout 2).
Caution Use caution when removing the e-clip because the clip might slip and shoot
towards you or another person.
Note Before removing the Jam Access Door six-sided shaft, note the position of
the plastic retainer that holds the metallic tape located at the center of the
door. It must be replaced on the shaft in the same position for proper paper
movement.
7From the front of the unit, support the door assembly while sliding the shaft
to the left until it is clear of the frame. The retaining springs and tape
retainer will fall free.
8Release the upper ends of the Paper Guide Strings (Figure 6-76, callout 3)
from the assembly.
To Reinstall:
1Attach the upper ends of the Paper Guide Strings to the door assembly
before installing it into the frame.
2Make sure that the retaining springs and the tape retainer are properly
positioned as you insert the shaft into the frame.
3Make sure that the retaining springs, e-clip, and copper grounding plate
are properly replaced on the shaft in the same position in which they were
removed.
6Removal and
Replacement
Removal and Replacement 6-87