Honeywell EN2Z-0906GE51 R0708 manual Cross Reference of iLON 10 Settings and Arena Settings

USER GUIDEARENA/ RANGER

Cross Reference of iLON 10 Settings and ARENA Settings

ARENA configures the iLON 10 when creating the site (see in “Create Site” section). If the iLON 10 configuration, e.g. user name or password, was changed manually afterwards, the ARENA settings must be changed accordingly. If ARENA settings and the iLON 10 settings are out of sync it may happen that the iLON 10 cannot be contacted anymore. For the accommodation of settings, use the following table.

General Settings page of iLON 10

iLON 10 Setting	ARENA Setting	Comment
IP Address	Outgoing connection: Remote Site IP	Used in LAN scenarios to contact the iLON
	Address	10. User needs Administrator privilege
Subnet Mask	Outgoing connection: Subnet Mask	Used in LAN scenarios to define the subnet
		to which the iLON 10 is connected.
		User needs Administrator privilege
Gateway Address	Outgoing connection: Gateway	Used in LAN scenarios to resolve
	Address	addressing if the iLON 10 and the
		supervisor PC are in different subnets.
		Contact the I.T. administrator to get the
		gateway’s IP address.
Explicit message -> Message with	-	Used to send an alarm from the controller
Code From / To		to the iLON 10. This has to be set "from 76
		to 76" and the setting has to be enabled.
		Otherwise no alarms will be sent out via
		the iLON 10.

PPPSettings page of iLON 10

iLON 10 Setting		ARENA Setting
Serial Port Baud Rate		-
Local IP Address for incoming calls		-
Use Static IP Address-> IP Address		-
Profile 1	-> User Name	Incoming Connection->User Name
Profile 1	-> Password	Incoming Connection->Password
Profile 1-> Phone Number		Incoming Connection -> Local Phone
		Number
Profile 1	-> Disconnect if idle for	-
Profile 1	-> Modem Init String	Incoming Connection -> Advanced
		settings -> Initialization string

Comment

Should be set to 57600

IP Address for PPP connections via modem. This is automatically generated by the ARENA site administration for Dial-Up scenarios.

IP Address for PPP connections via modem. This is automatically generated by ARENA site administration for Dial-Up scenarios.

User Name which the supervisor PC uses to authenticate an incoming call from the iLON 10.

Password which the supervisor PC uses to authenticate an incoming call from the iLON 10.

Phone number under which the supervisor PC can be reached for Dial- Up scenarios.

This time out applies if no LON connection can be made to the alarm receiver (ARENA). This should never happen. A good default would be 120 sec.

Init string which the iLON 10 uses each time it triggers a dial-out via modem. Via the init strings, special modem configurations can be made. Typical examples are:

X0: Do not wait for dial tone

M0 instead M1 to switch off the modem speaker.

A good default string for many modems is E0Q0V1S0=0&C1M1

If you need special settings, consult your modem manual and a description of the

59 EN2Z-0906GE51 R0708