
10: Configuration Pin Manager
i.Enter a group name in the Create Group field.
ii.Click Submit. Changes are applied immediately to the XPort AR.
c)To delete a CP group:
i.Select the CP group from the Delete Group
ii.Click Submit. Changes are applied immediately to the XPort AR.
d)To enable or disable a CP group:
i.Select the CP group from the Set
ii.Select the state (Enabled or Disabled) from the
iii.Click Submit. Changes are applied immediately to the XPort AR.
e)To set a CP group’s value:
i.Select the CP group from the Set
ii.Enter the CP group’s value in the value field.
iii.Click Submit. Changes are applied immediately to the XPort AR.
f)To add CP to a CP group:
i.Select the CP from the Add
ii.Select the CP group from the
iii.Select the CP’s bit location from the bit
iv.Click Submit. Changes are applied immediately to the XPort AR.
g)To delete a CP from a CP group:
i.Select the CP from the Remove
ii.Select the CP group from the
iii.Click Submit. Changes are applied immediately to the XPort AR.
2.If using Command Mode:
a)Type enable Æ cpm to access the CPM level menu.
b)Use the add, delete, and set commands to configure values within Command Mode (for more information on these parameters, see PPP Menu on page 91).
Note: Each CP with a bit position value of 1 (when the decimal value is converted to binary) has an asserted state.
XPort AR User Guide | 133 |