|
| 4: Configuration Using Web Manager |
|
|
|
|
|
| On Connection | Specifies the value to set the CP or CP Group when a |
|
|
| connection is established. |
|
| On Disconnection | Specifies the value used when the connection is closed. |
|
|
|
|
|
3. Click Submit. Changes are applied immediately to the XPort AR.
Disconnect Mode
Disconnect mode is disabled by default. When enabled, disconnect mode runs in the background of an active connection to determine when a disconnection is required.
To configure the tunnel’s disconnect mode:
1.Click Tunnel 1 Æ Disconnect Mode from the navigation menu. The Tunnel 1 Disconnect Mode window displays.
Figure 4-17. Tunnel 1 Disconnect Mode
2. Enter or modify the following fields:
Mode | Select Disabled to disable Disconnect Mode completely. |
| Select Timeout to enable Disconnect Mode upon the timeout. |
| Select Stop Character to enable Disconnect Mode upon |
| receiving the stop character. Select DSR Inactive to enable |
| Disconnect Mode if the Data Set Ready (DSR) pin is inactive |
| on the serial line. |
Timeout | Enter a time, in milliseconds, for the XPort AR to disconnect |
| on a timeout (if specified as the Mode). |
Flush Serial Data | Select Enabled to flush the serial data buffer on a |
| disconnection. |
3. Click Submit. Changes are applied immediately to the XPort AR.
Packing Mode
When in packing mode, data is not transferred one byte at a time. Instead, data is queued and sent in segments.
XPort AR User Guide | 33 |
