
4: Configuration Using Web Manager
Note: Both the IP and MAC addresses are required for the ARP cache.
Current State
Clear
Remove
Select Clear to remove all entries in the ARP table.
Removes a specific entry from the ARP table.
3.Click Submit after each modified field. Changes are applied immediately to the XPort AR.
PPP
The XPort AR supports two types of PPP authorization: Password Authentication Protocol (PAP) and Challenge Handshake Protocol (CHAP). Both of these authentication methods require the configuration of a username and password. It also supports no authentication scheme when no authentication is required during link negotiation.
Note: The following section describes the steps to configure PPP 1 (PPP on serial line 1); these steps also apply to PPP 2.
To configure the XPort AR’s PPP configuration:
1.Click Network Æ PPP Line 1 from the navigation menu. The PPP – Line 1 window displays.
Figure 4-4. PPP Settings
2. Enter or modify the following fields:
Mode | Select Enabled to enable PPP on the XPort AR’s serial line 1. |
|
|
Local IP Address | Enter the IP address assigned to the device’s PPP interface. |
|
|
XPort AR User Guide | 21 |