
Using the Tear Off bar
Setting the Tear Off position
When Auto Tear Off is On or set to One Second, it moves the top perforation of a continuous form to the Tear Off position when all of the following are true:
•The printer has finished printing.
•The paper has advanced to the
•No data, printer control codes, or escape codes have been sent to the printer after advancing to the
•The print buffer has not received data for one second.
If you have already set your
1Press Start/Stop to take the printer offline.
2Press and hold Tear Off until the printer beeps.
3Open the operator panel cover to access layer 2.
4Press Micro ↑ or Micro ↓ to move the paper to the correct position on the Tear Off bar.
5Close the operator panel cover. The printer beeps twice.
The paper rolls backward, then goes to the new Tear Off position.
6The Ready light is On.
7Press Start/Stop.
The paper remains at the current Tear Off position until you send another job to the printer. The paper moves from the Tear Off position to the
Loading paper
87