Diagnostic Procedures
This section provides a more detailed approach to diagnosing and identifying problems and then locating their sources.
Error Checking
Each time you turn on the system, POST
If POST finds an error, it displays an error message. Refer to the Error Message section in this chapter for an explanation of each error message.
Troubleshooting Guide
Use the following troubleshooting procedures to help you identify a problem. These general procedures lead you through the following:
!Preparing the system for diagnosing problems
!Monitoring POST while it is running
!Verifying proper operation of key system LEDs
!Confirming loading of the operating system.
Preparing the System for Diagnosing Problems
To prepare the system for diagnosing problems, perform the following:
Note: Before disconnecting any peripheral cables from the system, turn off the system and any external peripheral devices. Failure to do so can cause permanent damage to the system and/or the peripheral devices.
1.Turn off the system and all external peripheral devices. Disconnect all devices from the system except the keyboard and video monitor.
2.Make sure the system power cords are plugged into a properly grounded AC outlet.
3.Make sure your video display monitor and keyboard are correctly connected to the system. Turn on the video monitor. Set its brightness and contrast controls to at least
4.If the operating system normally loads from the hard disk drive, make sure there is no diskette in drive A. Otherwise, place a diskette containing the operating system files in drive A.
5.Turn on the system. If the power indicator LED does not light, refer to Power Light Does Not Light found later in this chapter.
