NEC 320Lb-R manual CD-ROM Drive Activity Light Does Not Light, Problems with Application Software

CD-ROM Drive Activity Light Does Not Light

Check the following:

!Is the power and signal cable to the CD-ROM drive properly installed?

!Are all relevant switches and jumpers on the drive set correctly?

!Is the drive properly configured?

!Is the onboard IDE controller enabled?

Problems with Application Software

If you have problems with application software, perform the following:

!Verify that the software is properly configured for the system. Refer to the software installation and operation documentation for instructions on setting up and using the software.

!Verify a different copy of the software to see if the problem is with the copy that you are using.

!Make sure all cables are installed correctly.

!Verify that the PCI board jumpers are set correctly. Refer to the Configuring Your System, Chapter 3 for jumper settings.

!If other software runs correctly on the system, contact your vendor about the failing software.

If the problem persists, contact the software vendor's customer service representative for assistance.

Bootable CD-ROM Is Not Detected

Check the following:

!Is the BIOS set to allow the CD-ROM to be the first bootable device? Check your BIOS Setup (F2) configuration.

5-12 Problem Solving