PCI Board

Retainer Bracket

Figure 4-30. Installing the PCI Board Retaining Bracket.

10.If installing a long PCI board, slide the bracket towards the rear of the module to fasten the other edge of the board. Tighten the bracket screw. See Figure 4-31.

Screw

Bracket

Figure 4-31. Adjusting the Card Bracket to Secure long PCI Boards.

11.Install the PCI module top cover, securing it with three screws.

12.Install the PCI module into the system cabinet following procedures previously detailed in this chapter.

13.Connect the network cables and option board cables.

14.Power on the PCI module and reboot the system to ensure POST does not display any error messages. If error messages are displayed, see the POST error messages listed in Chapter 5.

15.Boot the PCI module using the NEC ESMPRO Manager or the ft series utility to establish a dual configuration.

4-28 CRU Replacement and Server Upgrades

Page 119
Image 119
NEC 320Lb-R manual Installing the PCI Board Retaining Bracket