Diskette Drive Activity LED Does Not Light

Check the following:

!Are the diskette drive's power and signal cables properly installed?

!Are all relevant switches and jumpers on the diskette drive set correctly?

!Is the diskette drive properly configured?

!Is the diskette drive activity light always on? If so, the signal cable may be plugged in incorrectly.

Use BIOS Setup to make sure that the diskette drive controller is set to Enabled. For information about running BIOS Setup, refer to Configuring Your System, Chapter 3.If the problem persists, there may be a problem with the diskette drive, device backplane boards, or drive signal cable. Contact your service representative for assistance.

Problem Solving 5-11

Page 134
Image 134
NEC 320Lb-R manual Diskette Drive Activity LED Does Not Light