Omron CS1W-ETN21 operation manual +1 to m+8 Number of Bytes Received 0000 to 07C0 hex

DM Area Allocations Section 4-2

TCP Socket No. (1 to 8): Number of Bytes Received (Ethernet Unit to CPU Unit)

m+1 to m+8

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Number of Bytes Received (0000 to 07C0 hex)

For each TCP socket, the number of bytes of data in the reception buffer is stored in one word. A maximum of 4,096 bytes of data can be held in the reception buffer, but a value of only up to the maximum value (1,984 bytes) that can be set for receive requests by manipulating control bits or using CMND(490) is stored.

0000 hex: 0 bytes

07C0 hex: 1,984 bytes

The Data Received Flag in the CIO Area turns ON and OFF linked to this word. This area is given a value of 0000 hex when a receive request is exe- cuted by manipulating control bits or using the CMND(490) instruction. If any data remains in the reception buffer after the receive request processing is completed, the remaining number of bytes is stored and the Data Received Flag turns ON again.

Before a receive request is executed, a check is performed to confirm that the required data is available.

TCP Socket No. (1 to 8): Connection Status (Ethernet Unit to CPU Unit)

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

m+9 to m+16

TCP connection status

The connection status for each TCP socket is stored by code in this word. For details, refer to Appendix C TCP Status Transitions.

Socket Services Parameter Area 1 to 8 (Ethernet Unit to CPU Unit)

Offset	Socket	...	Socket
	No. 1		No. 8
+0	m+18	...	m+88
+1	m+19		m+89
+2	m+20		m+90
	m+21		m+91
+4	m+22	...	m+92
+5	m+23		m+93
+6	m+24		m+94
	m+25		m+95
+8	m+26		m+96
+9	m+27	...	m+97

15	14	13	12	11	10	9	8	7		6	5	4	3	2	1	0
		Socket option							UDP/TCP socket number (1 to 8)

Local UDP/TCP port number (0000 to FFFF Hex)

Remote IP address (00000000 to FFFFFFFF Hex)

Remote UDP/TCP port number (0000 to FFFF Hex)

Number of send/receive bytes (0000 to 07C0 Hex (1984))

Send/receive data address

(Same as FINS variable area designation method.)

Timeout value (0000 to FFFF Hex)

Response code

When socket services are requested by control bit manipulation, the settings must be made in advance in a Socket Service Parameter Area. The parame- ters used will vary depending on the service requested. For details, refer to Operation Manual, Construction of Applications, SECTION 6.

88