Omron CS1W-ETN21 operation manual Results Storage Format Parameters

Command/Response Reference Section 7-3

Response Block

27 13

Command Response

code code

Results Storage Format

Parameters

Socket Option (Command)

TCP Socket Number (Command)

Results Storage Area (Command)

Number of Bytes Sent

(Command, Results

Storage Area)

Data Sent (Command)

Response	Number of
code	bytes sent

The socket option specified as 1 byte. The setting is not valid for this com- mand. Set to 0.

The TCP socket number to send the data specified as 1 byte between 1 and 8.

The area in which the results of the command execution are stored. The first byte specifies the memory area and data type (variable type). The 2nd to 4th bytes specify the beginning address of the results storage area. Refer to page 158 for details about the variable types and addresses that can be spec- ified.

The number of bytes in the data sent specified between 0 and 1,984. The results storage area stores the actual number of bytes sent.

Specifies the data to be sent.

Response Codes

Response code	Description
0000	Normal
0105	Local IP address setting error
0302	CPU Unit error; execution not possible.
1001	Command too large
1002	Command too small
1003	The number of bytes sent does not match the amount of data.
1100	The TCP socket number or number of bytes sent is out of
	range.
1101	The variable type for the results storage area is out of range.
1103	Non-zero bit address specified for the results storage area.
220F	The specified socket is sending data.
2210	No connection could be established to the specified socket.
2211	High traffic at Unit; cannot execute service.

179