Omron CS1W-ETN21 operation manual Procedure for Creating I/O Tables

Creating I/O Tables Section 2-6

Connecting Programming Devices

Programming Console

Model number	Key Sheet (required)	Recommended cable (required)
C200H-PRO27-E	CS1W-KS001-E	CS1W-CN224 (cable length: 2.0 m)
		CS1W-CN624 (cable length: 6.0 m)
CQM1-PRO01-E		CS1W-CN114 (cable length: 0.1 m)

CX-Programmer (Version 3.20 or Higher) and CX-Integrator

The operations are explained here using a Programming Console. For details regarding the CX-Programmer and the CX-Integrator, refer to the CX-Pro- grammer User’s Manual. Refer to the CX-Integrator Operation Manual (W445) for connection procedures and operating procedures for the CX-Integrator.

CX-Integrator is software that comes with CX-One and is automatically installed when CX-One is installed.

To connect a Programming Console, attach a CS/CJ-series Key Sheet and then connect the Console to the CPU Unit’s peripheral port. (It cannot be con- nected to the RS-232C port.)

2-6-3 Procedure for Creating I/O Tables

The procedure for creating I/O tables is shown here, taking as an example I/O tables that is generated automatically for a PLC connected online. In this example, a Programming Console is used for creating the I/O tables. For an explanation of how to create I/O tables using a CX-Programmer, refer to the CX-Programmer User’s Manual.

Use the following procedure to create the I/O tables.

Note With the CJ Series, it is necessary to create I/O tables only when I/O alloca- tion is performed by the user. With the CS Series, it is always necessary to create I/O tables.

Initial screen

CH

SHIFT *DM

000000 I/O TBL ?

CHG

000000 I/O TBL

WRIT ????

WRITE

Password

000000CPU BU ST? 0:CLR 1:KEEP

or (Save or clear the CPU Bus Unit System Setup.)

000000 I/O TBL WRIT OK

40