User’s Manual of WGSD-1022/WGSD-8000

ƒforward — Forwards frames with unlearned source addresses, but does not learn the address.

ƒdiscard — Discards frames with unlearned source addresses. This is the default if no option is indicated.

ƒdiscard-shutdown— Discards frames with unlearned source addresses. The port is also shut down.

ƒtrap Seconds — Sends SNMP traps and defines the minimal amount of time in seconds between two consecutive traps. (Range: 1 - 1,000,000)

Default Configuration

Disabled - No port security

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

There are no user guidelines for this command.

Example

In this example, frame forwarding is enabled without learning, and with traps sent every 100 seconds on port e18. console (config)# interface ethernet e18

console (config-if)#port security forward trap 100

5.4.12 port security routed secure-address

The port security routed secure-addressinterface configuration command adds MAC-layer secure addresses to a routed port. Use the no form of this command to delete the MAC addresses.

Syntax

port security routed secure-address mac-addressno port security routed secure-address mac-address

ƒmac-address— Specify a MAC address.

Default Configuration

No addresses are defined.

Command Mode

Interface configuration (Ethernet, port-channel). Cannot be configured for a range of interfaces (range context).

User Guidelines

The command enables adding secure MAC addresses to a routed ports in port security mode. The command is available when the port is a routed port and in port security mode. The address is deleted if the port exits the security mode or is not a routed port.

- 177 –