Planet Technology WGSD-1022, WGSD-8000 5.15 Port Channel Commands, Syntax, Command Mode, User Guidelines, Default Configuration, 5.15.1 interface port-channel

						User’s Manual of WGSD-1022/WGSD-8000
------	--------	------------	------------	-----------	----------	---------
e1	48		5.15	50	1.789	No
e2	43		5.15	10	1.789	No
e3	Copper

Temp – Internally measured transceiver temperature.

Voltage - Internally measured supply voltage.

Current – Measured TX bias current.

Output Power – Measured TX output power.

Input Power – Measured RX received power.

Tx Fault – Transmitter fault

LOS – Loss of signal

Data ready – Indicates transceiver has achieved power up and data is ready.

N/A - Not Available, N/S - Not Supported, W - Warning, E - Error

5.15 Port Channel Commands

5.15.1 interface port-channel

The interface port-channelglobal configuration command enters the interface configuration mode of a specific port-channel.

Syntax

interface port-channel port-channel-number

ƒport-channel-number— A valid port-channel trunk index.

Default Configuration

This command has no default configuration.

Command Mode

Global Configuration mode

User Guidelines

Seven supported aggregated links are defined, and per port-channel, up to 4 member ports.

Turning off auto-negotiation of an aggregate link may, under some circumstances, make it non-operational. If the other side has auto-negotiation turned on, it may re-synchronize all members of the aggregated link to half-duplex operation, and may, as per the standards, set them all to inactive.

- 251 –