Planet Technology WGSD-1022, WGSD-8000 Syntax, Example, Command Modes, User Guidelines, Default Configuration, 5.7.21 port storm-controlbroadcast rate, 5.7.20 port storm-controlbroadcast enable

User’s Manual of WGSD-1022/WGSD-8000

Jumbo frames will be enabled after reset

5.7.20 port storm-control broadcast enable

The port storm-control broadcast enable interface configuration command enables broadcast storm control. To disable broadcast storm control, use the no form of this command.

Syntax

port storm-control broadcast enable

no port storm-control broadcast enable

Default Configuration

Broadcast storm control is disabled.

Command Modes

Interface Configuration (Ethernet) mode

User Guidelines

Use the port storm-control broadcast rate interface configuration command, to set the maximum allowable broadcast rate. Multicast can be counted as part of the "storm" frames if the port storm-controlinclude-multicastglobal configuration command is already executed.

Example

The following example enables broadcast storm control on port e5.

Console(config)# interface ethernet e5

Console(config-if)#port storm-control broadcast enable

5.7.21 port storm-control broadcast rate

The port storm-control broadcast rate interface configuration command configures the maximum broadcast rate. Use the no form of this command to configure the default value.

port storm-control broadcast rate rate

no port storm-control broadcast rate

ƒrate—Maximum of kilobytes per second of broadcast and multicast traffic on a port. (Rate: 70 - 100000)

-216 –