User’s Manual of WGSD-1022/WGSD-8000

Step6: Proceeds with the steps 4 and steps 5 of session 2.2.1 Desktop Installation to connect the network cabling and supply

power to the switch.

2.2.3 Installing the SFP transceiver

The sections describe how to insert an SFP transceiver into an SFP slot.

The SFP transceivers are hot-pluggable and hot-swappable. You can plug-in and out the transceiver to/from any SFP port without having to power down the Switch. As the Figure 2-7 appears.

Figure 2-7Plug-in the SFP transceiver

Approved PLANET SFP Transceivers

PLANET WGSD-Switch support both single mode and multi mode SFP transceiver. The following list of approved PLANET SFP transceivers is correct at the time of publication:

■MGB-SX SFP (1000BASE-SX SFP transceiver ) ■MGB-LX SFP (1000BASE-LX SFP transceiver )

It recommends using PLANET SFPs on the Switch. If you insert a SFP transceiver that is not

#Note: supported, the Switch will not recognize it.

Before connect the other switches, workstation or Media Converter.

1.Make sure both side of the SFP transfer are with the same media type, for example: 1000Base-SX to 1000Base-SX, 1000Bas-LX to 1000Base-LX.

2.Check the fiber-optic cable type match the SFP transfer model.

¾To connect to 1000Base-SXSFP transfer, use the multi-modefiber cable- with one side must be male duplex LC connector type.

¾To connect to 1000Base-LXSFP transfer, use the single-modefiber cable-with one side must be male duplex LC connector type.

Connect the fiber cable

- 22 –