User’s Manual of WGSD-1022/WGSD-8000

5.27.10 switchport trunk native vlan

The switchport trunk native vlan interface configuration command defines the port as a member of the specified VLAN, and the VLAN ID as the "port default VLAN ID (PVID)". To configure the default VLAN ID, use the no form of this command.

Syntax

switchport trunk native vlan vlan-id

no switchport trunk native vlan

ƒvlan-id— Valid VLAN ID of the active VLAN.

Default Configuration

VLAN ID=1

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

This command has the following consequences: incoming untagged frames are assigned to this VLAN and outgoing traffic in this VLAN on this port is sent untagged (despite the normal situation where traffic sent from a trunkmode port is all tagged). The command adds the port as a member in the VLAN. If the port is already a member in the VLAN (not as a native), it should be first removed from the VLAN.

Example

The following example e8, in trunk mode, is configured to use VLAN number 123 as the "native" VLAN.

Console (config)# interface ethernet e8

Console (config-if)#switchport trunk native vlan 123

5.27.11 switchport general allowed vlan

The switchport general allowed vlan interface configuration command adds or removes VLANs from a general port.

Syntax

switchport general allowed vlan add vlan-list[ tagged untagged ] switchport general allowed vlan remove vlan-list

ƒadd vlan-list— List of VLAN IDs to add. Separate non consecutive VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs.

ƒremove vlan-list— List of VLAN IDs to remove. Separate non consecutive VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs.

-350 –