Powerware 9330 operation manual To install an RMP, RMP Wire Terminations

5.2To install an RMP:

NOTE: 1. Before installing an RMP, be sure you have prepared the UPS according to the instructions in paragraph 2.2.7.

2.If mounting to a hollow wall, secure the enclosure bottom to a wood or metal stud within the wall. Do not use hollow wall anchors. The RMP also has provisions to be mounted to a single or double gang wall electrical box.

1.If wall mounting, securely mount the RMP. If desk mounting, install provided bumpers to the bottom of the RMP enclosure.

2.Install the Remote Monitor Card into an open x---slot on the rear panel of the UPS Cabinet, using supplied hardware.

3.If wall mounting, proceed to step 4; if desk mounting, proceed to step 5.

4.Install wiring from the RMP to the UPS using ½-in. conduit through the cable exit openings in the Remote Monitor Card (see Figure 5---2) and the RMP (refer to Drawing 164201300---19 in Appendix A). Proceed to step 6.

5.Install wiring from the RMP to the UPS using cable listed in Table 5---1 and provided strain relief bushings in the cable exit openings in the Remote Monitor Card (see Figure 5---2) and the RMP (refer to Drawing 164201300---19 in Appendix A).

6.Connect wiring between the RMP and the UPS Remote Monitor Card plug-in terminal blocks using terminations shown in Table 5---1. See Figures 5---2 and 5---3 for plug-in terminal block locations.

Table 5---1. RMP Wire Terminations

From RMP	To UPS	Remarks
	Remote Monitor Card
J1---1	J1---1
J1---3	J1---3
		Use Belden 8690 060
J1---4	J1---4
		or equivalent Cable
J1---5	J1---5
J1---6	J1---6

7.To check the operation of the RMP, ensure that the UPS system is supplying the load via the inverter or bypass. If the indicators on the RMP show the appropriate status, then it is operating correctly.

If the RMP is not operating correctly, check the wiring, the fuse on the Remote Monitor Card, and the plug-in terminal blocks for proper seating. If all connections are secure but the RMP still does not operate correctly, replace the fuse. If this does not correct the problem, contact your local field service office for verification that the RMP is working correctly.

5--2	Powerware 9330 (10 kVA--40 kVA) Installation and Operation
	164201300 REV. G 061502