
Section 6. Replacement Procedures
6.4 Replacing the Power Supply
The Power Supply is a
STEP PROCEDURE
1.Switch the printer OFF and disconnect the power cable.
2.Remove (3) screws holding the left side cover to the printer. Raise the access door and loosen the (2) screws on the inside top of the printer. Lift off the left side cover to expose the main PCB. Fig.
3.Remove (2) screws holding the I/O PCB Interface from the back end of the unit. Pull away to detach the connector on the interface from the main PCB. Figs.
4.Remove (2) screws to detach the main circuit board. Figs.
5.Remove (2) screws to which secures the board mounting plate to the back side of the unit. Fig.
6.Remove (2) screws to detach the Board Mounting Plate and carefully move out of the way of the Power Supply Assembly. Figs.
7.Remove (2) screws to which secures the power supply to the back side of the unit. Fig.
8.Lower the Media Holder in the mechanical section of the printer for access to
(2) screws holding the power supply. Remove the screws. Figs.
9.Detach (2) cable connections and remove the defective Power Supply. Fig.
10.Install a replacement Power Supply reversing steps 1 through 9.
11.Check the DC power voltages. Refer to Section 4.3.
PN 9001079 | SATO CL608e/CL612e Service Manual | Page |
Rev. B |
|
|