Section 9. Optional Accessories
Label Dispenser Installation
STEP PROCEDURE
4.Remove (3) motor mounting screws attaching motor to the frame. Fig.
5.Refer to Section 6.2 and remove the main circuit board.
6.Detach the front cover from the printer by removing (5) screws. Figs.
7.Refer to Fig.
Place spring on pin (both ends) and attach roller with flat area of shaft over spring and into hole (both ends).
8.Refer to Fig.
Install Dispenser Feed Roller Assembly through hole in space vacated by motor and into right side frame using hardware supplied.
9.Refer to Fig.
Install the Idler Gear directly above the gear on the end of the feed roller assembly installed in Step 8. The idler gear should mesh freely with feed roller gear when installed correctly.
10.Refer to Fig.
Install idler pulley with large teeth in/small teeth facing out.
11.Refer to Fig.
Remove the "E" clip and pulley from bracket. Route the drive belt over the gear. Insert the gear shaft through the hole in the printer wall. Attach the bracket to the printer wall from the opposite side with (4) screws provided. Install the "O" ring pulley, shoulder side first and reattach the "E" clip to the end of the shaft. Attach belt from the gear on this assembly to the gear on the idler pulley as shown in Figs.
12.Refer to Fig.
Attach the tension roller to the printer as shown in Figs.
13.Refer to Fig.
Install the rewinder assembly to the back of the printer with (2) screws provided. Run the "O" belt from the rewinder assembly through the back of the printer and onto the rewind pulley installed in step 11.
14.Refer to Fig.
Attach the pulley cover over the exposed pulley and belt with (1) screw provided.
PN 9001079 | SATO CL608e/CL612e Service Manual | Page |
Rev. B |
|
|
