Section 2. Configuration

LCD Panel — Clear Non-Standard Protocol

The standard protocol codes used by the printer can be modified to accomodate the requirements of different host systems. However, if the printer is to be used with a system that does not use the custom protocol codes, they can be cleared and the default protocol codes reactivated.

The default values are:

STX = 7BH, ETX = 7DH, ESC = 5EH, ENQ = 40H, NULL = 7EH,

CAN = 21H and OFFLINE = 5DH.

Alt. Protocol Default Complete

initializing

rom v00.00.00.00

alt protocol default complete

To Clear Non-Standard protocol codes, place DSW2-7 in the ON position and power on the printer while simultaneously pressing the LINE and FEED keys.

STEP

PROCEDURE

1.When the printer emits one long beep release the LINE and FEED keys.

2.When the keys are released, the printer will replace the Alternate protocol codes with the default values.

3.After the default setting is complete, the printer will emit three short beeps indicating that the process is complete.

To exit the mode, power the printer off, then back on.

Download User Defined Protocol Codes

The user can define a set of custom protocol codes and download them to the printer using the <ESC>LD command.

User Download Press the Line Key

initializing

rom v00.00.00.00

user download press the line key

To enter the User Download mode, place DSW2-7 in the ON position and power on the printer while simultaneously pressing the LINE key. When the printer emits one long beep release the LINE key.

STEP

PROCEDURE

1.Set DSW2-7 to the OFF position to replace the Standard protocol codes or ON to replace the Alternate set of protocol codes.

2.Press the LINE key. The printer is now waiting for the data to be sent.

user download

waiting

PN 9001079

SATO CL608e/CL612e Service Manual

Page 2-37

Rev. B

 

 

Page 59
Image 59
SATO CL608e/CL612e User download Waiting, LCD Panel Clear Non-Standard Protocol, Download User Defined Protocol Codes