SATO CL608e/CL612e Replacing the Display Panel or Keyboard, Raise Access Door Display Panel Cover

Section 6. Replacement Procedures

6.13 Replacing the Display Panel or Keyboard

STEP PROCEDURE

1.Switch the printer OFF and disconnect the power cable.

2.Remove (3) screws holding the left side cover to the printer. Raise the access door and loosen the (2) screws on the inside top of the printer. Lift off the left side cover to expose the main PCB. Fig. 6-1

3.Raise the access door. Remove (1) screw from the cover that is attached to the frame. The location is where the platen goes through the casting. Fig. 6-75 & 6-76

4.Remove (2) screws from cover. Fig. 6-77

5.In the electronics compartment, detach cable marked KB from the Display Panel back.

6.Remove (2) screws from the back plate that is secured to the cover and the Display Panel Assembly. Fig. 6-78 Rotate forward and lift to detach the cover. Fig. 6-79

7.In the mechanical section, remove (1) screw that attaches the Display Panel Assembly to the frame. Fig. 6-80

8.Remove (2) screws from the bottom of the Display Panel Assembly. Fig. 6-81

9.Lift to remove the Display Panel Assembly. Fig. 6-82

10.Install a replacement display panel or keypad.

11.Reinstall Display Panel Assembly using screws previously removed.

12.Reconnect KB cable to the display after reinstalling assembly.

13.Reinstall Cover.

14.Replace the left side cover and reconnect the power cable.

RAISE THE

ACCESS DOOR

DISPLAY

PANEL

COVER

Fig. 6-75

PN 9001079	SATO CL608e/CL612e Service Manual	Page 6-37
Rev. B