Section 9. Optional Accessories

9.5 Flash Memory Expansion Installation

STEP PROCEDURE

1.Switch the printer OFF and disconnect the power cable.

2.Remove (3) screws holding the left side cover to the printer. Raise the access door and loosen the (2) screws on the inside top of the printer. Lift off the left side cover to expose the main PCB. Fig. 9-23

3.Carefully press outward on the tabs on both ends of the Main PCB Board Memory Frame to release the Standard Memory PCB. The Stan- dard Memory PCB should lift by itself when released. Remove the Memory PCB from the frame. Note the indexing notches. Figs. 9-24

4.Remove the Flash Memory Module from the anti-static bag handling the

module by the edges. Note the indexing notches. Insert the module into the Main PCB Memory Frame at approximately 450 away from the Main PCB Board. Gently push down to snap into position. Figs. 9-25

5.Replace the cover reversing removal steps.

6.Complete the Factory Reset Procedure.

* PRESS OUTWARD

STANDARD MEMORY PCB IN THE

 

MAIN PCB MEMORY FRAME

Figs. 9-24

INDEXING

 

NOTCHES

* CAREFULLY PRESS OUTWARD

ON TABS ON BOTH ENDS OF THE

* PRESS OUTWARDFRAME TO RELEASE THE MEMORY PCB.

PN 9001079

SATO CL608e/CL612e Service Manual

Page 9-19

Rev. B

 

 

Page 191
Image 191
SATO CL608e/CL612e manual Flash Memory Expansion Installation, Press Outward, Indexing, Notches