
Section 6. Replacement Procedures
Replacing the Paper End Switch
The Notch/Gap and
STEP | PROCEDURE |
1.Switch the printer OFF and disconnect the power cable.
2.Remove (3) screws holding the left side cover to the printer. Raise the access door and loosen the (2) screws on the inside top of the printer. Lift off the left side cover to expose the main PCB. Fig.
3.Remove the ribbon and label stock if installed. Fig.
4.Raise the media
5.Loosen screws from idler gear plate for access to screw. Remove (3) screws to detach the opposite end of the ramp plate from back plate (electronics section). Fig.
6.Detach connections from the main PCB harness to the sensors on the ramp plate.
7.Carefully wiggle the ramp plate free from the ramp frame and the printer. Fig.
8.Turn the ramp plate over to expose the sensors. Fig.
9.To replace the Paper End Switch, remove (2) screws that attach the switch to the bracket. Install a replacement switch. Fig.
10.To replace the bottom half of the Notch/Gap and
NOTE: If plastic windows are scratched or otherwise damaged, they should be replaced.
11.Reattach the ramp plate to the ramp frame. Attach connections from the sensors to the PCB harness insuring that cable, (Paper End Switch), passes under the paper feed platen and the cable for the gap sensor is properly routed through notch in ramp plate.
12.Replace the left side cover and reconnect the power cable.
PN 9001079 | SATO CL608e/CL612e Service Manual | Page |
Rev. B |
|
|